The Vinci X by Voopoo is a pod system starter kit. It features the advanced Gene.AI chipset, a 5-70W wattage range, and is powered by a removable 18650 battery (not included). Rapidly click the power button 5 times to turn the device on or off, and hold the button down to activate the atomizer. Compatible with the Voopoo PnP series of replacement coils.
Warning: This device’s USB port is for firmware updates only, do NOT charge external batteries through your device’s update port.
– 1x VINCI X Device
– 1x 5.5mL VINCI Refillable Pod
– 1x 0.3ohm PnP-VM1 Mesh Coil
– 1x 0.6ohm PnP-VM4 Mesh Coil
– 1x Micro-USB Update Cable
– 1x Warranty Card
– 1x User Manual
– 1x Chip Card
– Size: 117 × 29.5 × 25.3mm
– Battery: Single 18650 (Not Included)
– Material: Zinc Alloy Body – PCTG Pod
– Juice Capacity: 5.5ml
– Side Fill Silicone-Stopper
– Output Power: 5-70W
– Voopoo PnP Replacement Coil Series
– 1.0ohm R2 Dual Coil – 10-15W
– 0.8ohm R1 Dual Coil – 12-18W
– 0.6ohm M2 Mesh Coil – 20-28W
– 0.3ohm VM1 Mesh Coil – 32-40W
– 0.45ohm VM3 Mesh Coil – 25-35W
– 0.6ohm VM4 Mesh Coil – 20-28W
– 0.2ohm VM5 Mesh Coil – 40-60W
– 0.15ohm VM6 Mesh Coil – 60-80W
– 0.6ohm TM1 Mesh Coil – 20-25W
– Resistance: 0.1-3.0ohm
– Plug and Play Coil Installation
– Magnetic Pod Connection
– Threaded Battery Door
Helpful hints for your new pod system!
– After filling a new cartridge allow it to sit for 10 minutes before use, allowing the cotton to saturate thoroughly.
– Clean your device on a regular basis by wiping any excess liquid from the inside of your battery and off of any contacts on either the cartridge or the battery. Use a Q-tip or a tissue.
– Charge your device in a flat, well-ventilated area. Do not leave it unattended while charging. Remove when fully charged.
– Only use the charging cable supplied with your device.
– Only use a 1-amp (or lower) charging block.
– Do not use the device while it is charging.
– Store your device in a cool dry place.
– Stay hydrated!!!!