Voopoo Drag 2 Refresh Kit

$84.95

The Drag 2 Refresh Kit by Voopoo is a regulated box mod starter kit.

SKU: 400000049038 Categories: , , , , Product ID: 12584

Description

The Drag 2 Refresh Kit by Voopoo is a regulated box mod starter kit. It features a 5-177W range, an extensive TC mode, a GENE Fit Chip, and requires 2 high-amp external batteries for power (not included). The included PnP Pod Tank is a bottom-fill 510 threaded tank and can utilize any coil in the Voopoo PnP series of coils.

Warning: This device’s USB port is for firmware updates only, do NOT charge external batteries through your device’s update port.

Kit Contains:

– 1x Drag 2 177W TC Mod
– 1x PnP Pod Tank
– 1x 0.15ohm PnP-VM6 Coil
– 1x 0.2ohm PnP-VM5 Coil
– 1x User Manual
– 1x Micro-USB Update Cable
– 1x Warranty Card

Specification:

– Battery: Dual 18650 (Not Included)
– Dimensions: 88.3 x 51 x 26.5
– Output modes: VW / TC (Ni, Ti, SS)
– Output wattage: 5-177W
– Resistance range: 0.05-3.0ohm
– OLED Screen
– Single Firing Button
– Two Adjustment Buttons
– Micro-USB Update Port
– 510 Threaded Connection

Voopoo PnP Tank Features:

– 26mm Diameter
– 4.5mL Refillable Pod Capacity
– Silicone-Stopper Bottom Fill System
– VOOPOO PnP Replacement Coil Series
– 0.6ohm PnP-M2 Coil – Rated 20-28W
– 0.8ohm PnP-R1 Coil – Rated 12-18W
– 1.0ohm PnP-R2 Coil – Rated 10-15W
– 0.3ohm PnP-VM1 Coil – Rated 32-40W
– 0.45ohm PnP-VM3 Coil – Rated 25-35W
– 0.6ohm PnP-VM4 Coil – Rated 20-28W
– 0.2ohm PnP-VM5 Coil – Rated 40-60W
– 0.15ohm PnP-VM6 Coil – Rated 60-80W
– 0.15ohm PnP-TM1 Coil – Rated 20-25W
– Bottom Press-Fit Coil Installation
– Dual Slotted Bottom Airflow Control Ring
– 510 Threaded Connection

Helpful hints for your new tank!

– Prime your new coil/atomizer before use. Thoroughly saturate dry cotton with liquid, reassemble tank and let it sit for 10 minutes (Do not over-tighten).

– If your device is adjustable, set it to your coil’s recommended wattage range.

– Do not run your tank dry. Be sure it is filled.

– Change your coil when it tastes burnt. Remove your entire tank from your device and disassemble it. Remove the burnt coil and clean your tank by rinsing it with water and swabbing any build-up with a Q-tip or tissue. Dry your tank and screw in your new coil snuggly (Do not over tighten any part of your tank).

– Familiarize yourself with using the adjustable airflow ring.

– Stay hydrated!!!!

Shipping/Delivery Notes

This product is only available for delivery in the following states: Alabama, Alaska, Arizona, Arkansas, California (Except San Francisco), Colorado, Connecticut, Delaware, Florida, Georgia, Idaho, Hawaii, Illinois (Except Chicago), Indiana, Iowa, Kansas, Kentucky, Louisiana, Maine, Maryland, Minnesota, Mississippi, Missouri, Montana, Nebraska, Nevada, New Hampshire, New Jersey, New Mexico, North Carolina, North Dakota, Ohio, Oklahoma, Oregon, Pennsylvania, South Carolina, South Dakota, Tennessee, Texas, Utah, Virginia, Washington, West Virginia, Wisconsin, Wyoming.

Reviews

There are no reviews yet.

Be the first to review “Voopoo Drag 2 Refresh Kit”

Your email address will not be published. Required fields are marked *

Minimum 8 characters