Voopoo Argus GT Kit

The Argus GT Kit by Voopoo is a regulated box mod starter kit. It features a 5-160W range, an extensive TC mode, a Smart VW Mode to prevent accidental coil burnout, and a Voopoo PnP Pod Tank. The Argus GT requires 2 high-amp 18650 for power and utilizes a GENE.TT chipset for rapid activation. The included PnP Pod tank is an impact resistant 510 threaded tank and can utilize any coil in the Voopoo PnP series of coils.

Warning: This device’s USB port is for firmware updates only, do NOT charge external batteries through your device’s update port.

Contains:

- 1x VOOPOO ARGUS GT
- 1x Voopoo PnP Pod Tank
- 1x Voopoo PnP 0.15ohm Coil
- 1x Voopoo PnP 0.2ohm Coil
- 1x USB-C Update Cable
- 1x User manual
- 1x Hard-Shell Case

Specification:

- Battery Compatibility: 2 x 18650 (sold separately)
- Dimensions: 132.1 x 51.3 x 26.1mm
- Output modes: VW(Smart) / VW(Regular) / TC (Ni, Ti, SS)
- Output wattage: 5-160W
- Resistance range: 0.1-3.0ohm
- OLED Display Screen
- Single Firing Button
- Two Adjustment Buttons
- Bottom Hinge Battery Door
- 510 Threaded Connection

Voopoo PnP Pod Tank Features:

- 26mm Diameter
- 4.5mL Refillable Pod Capacity
- Silicone-Stopper Bottom Fill System
- VOOPOO PnP Replacement Coil Series
- 0.6ohm PnP-M2 Coil - Rated 20-28W
- 0.8ohm PnP-R1 Coil - Rated 12-18W
- 1.0ohm PnP-R2 Coil - Rated 10-15W
- 0.3ohm PnP-VM1 Coil - Rated 32-40W
- 0.45ohm PnP-VM3 Coil - Rated 25-35W
- 0.6ohm PnP-VM4 Coil - Rated 20-28W
- 0.2ohm PnP-VM5 Coil - Rated 40-60W
- 0.15ohm PnP-VM6 Coil - Rated 60-80W
- 0.15ohm PnP-TM1 Coil - Rated 20-25W
- Bottom Press-Fit Coil Installation
- Dual Slotted Bottom Airflow Control Ring
- 510 Threaded Connection

Helpful hints for your new tank!

– Prime your new coil/atomizer before use. Thoroughly saturate dry cotton with liquid, reassemble tank and let it sit for 10 minutes (Do not over-tighten).

– If your device is adjustable, set it to your coil’s recommended wattage range.

– Do not run your tank dry. Be sure it is filled.

– Change your coil when it tastes burnt. Remove your entire tank from your device and disassemble it. Remove the burnt coil and clean your tank by rinsing it with water and swabbing any build-up with a Q-tip or tissue. Dry your tank and screw in your new coil snuggly (Do not over tighten any part of your tank).

– Familiarize yourself with using the adjustable airflow ring.

– Stay hydrated!!!!